TP2510N8-G is a -100V P-channel enhancement MOSFET, with N8 identifying 3-lead SOT-89. Evaluate real gate-source voltage, conduction loss and package cooling; a -1.5A electrical test does not establish continuous load capability.

1. Keep manufacturer conditions intact

Microchip specifies maximum 3.5Ω at VGS=-10V, ID=-750mA, and 7Ω at -5V, -250mA. Its thermal table separately lists -480mA continuous, junction-temperature limited, and 1.6W at 25°C on the specified FR5 board.

These describe different tests. The -1.5A ID(ON) item must not become a promise of continuous 1.5A on any SOT-89 board. Keep conditions in the engineering comparison instead of combining favorable numbers from unrelated rows.

2. Low threshold is not full enhancement at 3.3V

Threshold concerns the onset test. A switch design needs appropriate resistance and current evidence at its available VGS. For a P-channel high-side circuit, compute gate voltage relative to source, not the MCU’s output relative to ground.

Moving to a higher bus can greatly increase negative VGS when the gate is pulled down. The gate-source limit is ±20V. Engineering should review normal and transient drive or clamping, rather than purchasing another part merely because it is described as low-threshold.

3. A 200mA loss illustration

Using a resistor model only, 3.5Ω at 200mA gives about 0.14W; an assumed 7Ω gives 0.28W. Neither is a guaranteed resistance at that operating point, and neither includes high temperature, voltage transitions or switching loss.

The example shows why insufficient drive can increase heating. Record VGS, switch drop, current and temperature together. Capacitive startup and inductive turn-off can impose stresses absent from steady state; one settled temperature reading is not the whole qualification.

4. Verify the SOT-89 connections

Check the drawing and tab connection. The TP2510 pin table identifies pin 1 as Gate, 2/4 as Drain and 3 as Source. Another SOT-89 device need not match these connections. Compare footprint, electrical performance and safe operating limits.

The ordering data lists 2,000 pieces per reel. A requirement for 6,000 pieces needs a packing agreement: three reels, cut tape or another form. A numerical multiple alone does not prove unopened original packing.

5. Prepare an actionable RFQ

TP2510N8-G; quantity ___; bus and transients ___; continuous/peak load ___; available VGS ___; load type/duty ___; footprint revision ___; full reel/cut tape ___; acceptable dates/lots ___; destination and arrival ___.

Source and date-code assessment needs labels and supply records. Sales wording alone does not authenticate goods. Request a documented difference review and engineering approval for any proposed P-channel substitute.

Frequently asked questions

Can -1.5A be advertised as continuous current? No; distinguish the electrical test from the thermal table.

Is a larger package automatically a better substitute? Pinout, drive and dynamic behavior still need review.

Product lookup and enquiry

An exact product-detail page on this site was not verified for this code. Submit the complete code through the WOMAIELEC enquiry page. Include quantity, application and the operating conditions above. Price, stock, delivery, lot and document availability require confirmation per order.

Manufacturer references

Manufacturer product reference 1; Manufacturer technical reference 2. Reviewed November 17, 2026. This guide does not replace design qualification or guarantee inventory or authenticity.