TC4420COA713 is a single non-inverting MOSFET gate driver. Its 6A figure describes peak drive, not a continuous 6A load supply. It rapidly charges and discharges gates. Review polarity, supply, gate charge and temperature grade together.
1. What the complete suffix establishes
Microchip identifies TC4420 as non-inverting and TC4429 as inverting, with a 4.5–18V supply range. C specifies 0 to +70°C, OA is 8-pin SOIC and OA713 is the tape-and-reel version. Do not transfer E- or V-grade temperature coverage into TC4420COA713.
A standard ground-referenced low-side driver does not automatically supply floating high-side drive, half-bridge dead time or isolation. Review the full topology when those functions are needed; peak current alone does not replace a specialized driver.
2. Peak 6A versus average gate current
Assume a MOSFET with 20nC total gate charge at 100kHz. The average charging current estimate is Qg×f=2mA. At an assumed 10V drive, the corresponding gate-charge supply power is about Qg×V×f=20mW. These idealized calculations exclude quiescent current and real waveform losses; they do not mean all 20mW is dissipated inside the driver.
Peak drive affects charging transients and switching time; average current helps size supply and energy demand. Do not interchange them. Use the target MOSFET’s charge data at relevant drain and gate conditions.
3. Review logic input separately from drive voltage
Controller logic levels and driver supply serve different roles. Compare input thresholds with worst-case controller outputs, then check that the drive swing enhances the MOSFET without violating its gate-source limits. Raising drive voltage is not automatically an improvement.
Gate resistance, parasitics and MOSFET dynamics determine the useful switching speed. Compare loss, ringing and unintended turn-on rather than optimizing rise time alone.
4. Layout can change sample results
Decoupling must support fast gate-current loops. Driver-to-MOSFET routing, ground return and probing affect observed performance. Follow the package pinout, including required duplicate output and ground connections; do not infer connections or leave required duplicates open.
Record actual VDD, logic amplitude, MOSFET model, frequency, load, gate resistance and temperature. Control measurement conditions before comparing lots or substitutes. Probe-ground artifacts should not be mistaken for chip defects.
5. Compare offers and send the RFQ
TC4420COA713; quantity ___; non-inverting requirement ___; driver supply ___; control logic ___; MOSFET and Qg conditions ___; frequency ___; ambient ___; SOIC-8 packing ___; dates/lots/documents ___; destination and arrival ___.
An offer changing to TC4429, EOA or another family needs separate polarity, temperature and interface reviews. Equal package and “6A” do not prove compatibility. Actual available quantity and delivery conditions require confirmation for each order.
Frequently asked questions
Can the output directly supply a 6A motor? No. This is a gate driver; design its topology and output use according to the datasheet.
Can the C code be described as -40°C industrial grade? No. C and E grades differ.
Product lookup and enquiry
View TC4420COA713 product details and request a quote. Include quantity, application and the operating conditions above. Price, stock, delivery, lot and document availability require confirmation per order.
Manufacturer references
Manufacturer product reference 1; Manufacturer technical reference 2. Reviewed November 17, 2026. This guide does not replace design qualification or guarantee inventory or authenticity.
